Finding a Good Plumber Chicago That is Reliable

Finding a Good Plumber Chicago That is Reliable

The main reason of water main repairs is leakage and it occurs where two or more pipes are
connected and that point is known as a joint. So the leakage usually occurs at the joints. Before
removing or repairing a joint you first need to know the types of the joints so that you can repair them accordingly. The three main types of joints are the soldering joint, compression joint and the push fit connections.
In the soldering joints, the commonly used ones are those having the integral solder ring. In this case it’s very difficult or rather impossible to repair as once the water starts to run through the joint it cannot be soldered due to the water. You can repair it by removing a small section of the pipe with the joint in between the section and then put a new pipe with joints on both the ends. Before introducing such a joint you should first clean the pipe and it should also be dried as well. The heat used to solder must be even for proper sealing. When you repair such a joint, you should first remove the water in the pipe before heating the pipe. Then you should apply even heat until you see the ring around the joint meaning that now it has been properly sealed.

The second type of joint is the compression fitting joint. In this fitting, there is a small bearing inside the pipe. It is compressed between the fittings and hence the seal is formed. This type of joint is so easy to repair as all you need to do is hold the body of the joint with a pipe ranch and then tighten the side where it is leaking. Be careful that you don’t overdo the tightening or else the leakage at the joint might get worse. If you are able to resolve the leakage problem by just doing this its fine otherwise replace the joint or call in a professional plumber chicago and seek his help. If you are unable to remove the joint then the only option you will be left with will be to cut the joint and you can easily do it with a hacksaw.
The third type of join is the push fit fittings. If it is leaking it will require quite some investigation as there might be more than one or two reasons. But first of all check if the pipe is set up to the stop if it is not so then push the pipe in and it will be resolving the problem. If still there is a leak then there are specific tools to open this kind of joint you will need specific tools. You can also check the securing rings if they are damaged then they also might be a cause of the problem. All this might seem simple and easy but when doing it practically it becomes difficult so be careful and be prepared if you think that you can handle such type of problems well and good otherwise contact a professional to solve the water main repairs problem.

Comments are closed.